Separate names with a comma.
My last remap was custom.
I've done a fair few bits since.
Was just wondering what else I could do to get as much power as possible without...
Plugs and coils were replaced about three four weeks ago
My decat is a 3" downpipe
Thinking about going for stage 2 remap.
So far the mods I have are as follows:
Aluminium bigger smic
All silicon boost pipes
Wouldn't it be easier to hybrid the original ko3s turbo?
What else do I need for stage 2?
It's not over fueling with the 4bar fpr
no it was a custom map on a rolling road.
I was thinking around 235ish (torque)
I have done a few bits since the remap.
decat and 4 bar fpr.
I had a remap recently and I'm not sure if my torque figures are as good as they should be.
I'm running 211bhp 220lb/ft torque. 21psi boost
I was going to but couldn't find the spec of the nuts and bolts.
Ordered some from seat and I'm going to get the spec of them so I can get some...
I'm struggling to get some studs and nuts for the turbo to cat.
Two bolts have managed to fall out and it's blowing badly.
I need to...
Just got under my bonnet.
My dipstick guide wasn't even attached. It had snapped and the old owner and just bodged it back together.
Luckily had a...
yeah its coming up with missfire cylinder 4. cant remember the code but thats pretty much all it says
I have replaced all four coilpacks and checked all vac pipes.
I have a missfire on cylinder 4.
I replaced the coils because i was getting...