Jetex cat-back

[denzil691]

went to put on my jetex cat back today where it joins to the cat there is an inch gap it sits on the pipe but doesn't cover up the the lines for it it's a standard downpipe & cat could i just weld a another onto the centre section to get it to go over them?

Any help appreciated as my standard exhaust is blowing a fair bit.

Thanks

 

[tashacupra]

You should have been supplied with a small transition tube as the jetex cat back tube is slightly diffrent size to the stock DP/Cat. This is how mine is anyway, i dont run my center section any more as i have a non res section, and custom DP so i have the center section laying in the garage with the transition tube still in it iirc, i'll get a pic when i can.

Cheers Tasha.

 

[tom w]

You can buy exhaust couplers to bridge the gap in stainless also under a £10 too

 

[denzil691]

Thanks for the help ended up welding an inch on the centre section and clamping it onto the cat as
The standard d/p n cat are soon to go

 

[denzil691]

Tashacupra where abouts In Suffolk are you

 

[tashacupra]

Tashacupra where abouts In Suffolk are you

Oulton broad, although you won't see the ibiza about if your local as it's been off the road for quite some time now whilst my other half complet's a BT conversion on it, I have a mk2 facelift Leon now so have pritty much given the ibiza to my Bf to play with as he has just sold his last project.