hi,just chaging the bottom arm on my car and i have got all nuts undone ok,i haven also undone balljoint nut but the whole balljoint just spins with the nut and therefore cant wind the nut off the thread any tips?
Best way is to use a decent hacksaw to cut through the balljoint just below the nut once its slackened slightly, someone else on here gave me that advise and took 5 mins tops, the new balljoints should be tight enough being new to assemble without spinning
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.