Turbo Bracket Bolts

[Cupra137]

Anyone know the size/thread of the ko3 turbo bracket? Mine decided to leave the car the other day and I lost all the bolts in the process.

Thanks

 

[Cammy]

Oooosh, cars falling apart already lol

Phone TPS - 01224 409409

Ask for the part number of it, then ask the size of it, should be able to tell you In seconds

 

[Cupra137]

Haha yeah, but at least mine runs
Got some bolts from work that il try tomorrow but if not il have to ring, pretty sure they were allen key bolts but just need the thread

 

[Cammy]

Mines run scince 2 days after I bought it with a ****ed engine just with this k04 conversion, it runs and drives.. but it needs mapped badly (getting basemapped tomorrow )

Tried searching on ETKA? ive had a look myself but nothing that's easily seen tbh.

 

[Cammy]

then the part numbers and sizes for what I think is turbo bracket?

5 - 06A145536B


support part


_____________________
6 - N 01024710



bolt, hexagon head self-locking
M8X35 /

_______________________
7 -N 10303603



hexagon socket head bolt with collar
M8X16 /

 

[Cupra Tommy]

The two lower bolts are the same thread size as the allen key bolts that are used on the inlet manifold and most the other allen key bolts in the engine bay,the top bolt is either m8 or m10!!

 

[ibizacupra]

M10

 

[Cupra137]

Tidy. Thanks guys, i got it back on now, top bolt is pretty fiddly to get right thought

 

[Lowry020505]

iv just replaced my turbo yesterday,, there's 3 bolts, all m8 and the thread size is 1.5m the 2 that go in the block are about 10m long the other one that bolts the mount to the turbo is about 20m-25m
there pretty easy to get at,, with some axel stands

bolts require a 13 socket/spanner to fit them,
the drive shaft does obstruct you a bit but you can get around it

 

[Lowry020505]

iv just replaced my turbo yesterday,, there's 3 bolts, all m8 and the thread size is 1.5m the 2 that go in the block are about 10m long the other one that bolts the mount to the turbo is about 20m-25m
there pretty easy to get at,, with some axel stands

bolts require a 13 socket/spanner to fit them,
the drive shaft does obstruct you a bit but you can get around it

that's for an AUQ engine