what have you done to your car today ?
- Thread starter seatcupramad23
- Start date
Hi mate just wondered what gauges and pillar pods you have to instal and pics? I'm looking at getting a nomad single pillar pod and 52mm r spec stepper motor psi boost gauge. Would be good to get your opinion of yours.
Sent from my iPhone using Tapatalk
My Lc's been running like a bag of shite the past couple of days, lumpy idle cutting out the works so today I changed the maf and got some new Bosch 2.0 tfsi coilpacks and adapters, fitted em and took it for a run. The idles now smooth ,but still cut out at two sets of traffic lights![[:@]](/forums/styles/seatcupra/oldforumsmileys/furious.gif "Furious [:@]")
so next it'll be to clean the throttle body and sensor and see if that cures that.
so next it'll be to clean the throttle body and sensor and see if that cures that.
Did some cooking.
Dunno why it turned out so dark.... Little disappointed... But better then it was !
Dunno why it turned out so dark.... Little disappointed... But better then it was !
The lcr gad a stage 2 map today, achieved 283.9bhp and 276.7 torque. Badger5 gear based boost is awesome, and so is the map it's a different car completely! Very chuffed.
Went back to summer wheels, as the temps will stay above 7 degrees here in the Netherlands. Also stuck some tape on a wheel as a test (instead of tyre white). Please note: It sits high because I just got it of the jack.
Summer Reifen enabled by ND-Photo.nl, on Flickr
Wheel tape (test) by ND-Photo.nl, on Flickr
Summer Reifen enabled by ND-Photo.nl, on Flickr
Wheel tape (test) by ND-Photo.nl, on Flickr
Last edited:
Replaced the front wipers with some Bosch Aerotwins.
More importantly serviced the Forge 007p I bought on EBay and installed it.
What a difference it makes!
More importantly serviced the Forge 007p I bought on EBay and installed it.
What a difference it makes!
Took the **** universal cone filter off and re fitted the standard (drilled) air box and filter 
but just remembered I forgot to re attach the sai pipe doh! Lol
but just remembered I forgot to re attach the sai pipe doh! Lol
Did some cooking.
Dunno why it turned out so dark.... Little disappointed... But better then it was !
[url=https://flic.kr/p/r1htMa]
WhanAB spacer & shield by whanabiv, on Flickr[/URL][url=https://flic.kr/p/rhGXa8]
WhanAB spacer & shield by whanabiv, on Flickr[/URL][url=https://flic.kr/p/rfpMuo]
WhanAB spacer & shield by whanabiv, on Flickr[/URL][url=https://flic.kr/p/rhyVeB]
WhanAB spacer & shield by whanabiv, on Flickr[/URL]there is a 3/16 inch spacer between valve cover and the polished/mirrored aluminium shield and the wires are also protected by Heat Shield high heat wrap has a open air flow from right to left.............
We also used Heat Shield high heat wrap on the Timing Chain Cover as it was getting some much heat from the upgraded turbo it was melting... Just an FYI on that.......
We are going to start selling the spacer kit for the valve cover.... What do you think of it ?????
it is held down with the existing bolt for the ground
Similar threads
