Separate names with a comma.
do you know what pressure your car should be running?
id start looking at your diverter valve if you mention flutter.. vac hoses, then...
Check your anti roll bar as well mate
mine was bent after i had a 'bump'
Welcome to SCN
And congrats on your pending bambino :thumbup:
Love this, just amazing attention to detail :thumbup:
not a fan of the wrinkle, but that orange though... :drool:
Now this a blast from the past!!
i remember fitting all this to that car after chris basically bought my whole setup!
Glad its all still going...
naaa, used to go to the local meets off here, and go ultimate dubs etc etc..
bagillt isnt far from me though, if you ever need any help with your...
Welcome to SCN :thumbup:
you will have to post some pics up
Another member from north wales :)
can buy a hardpipe with map sensor on from forge motorsport :) they are in the traders section on here
to get the squashed pipe out you have to...
on your intercooler piping you want to get rid of the squashed pipe going inbetween your subframe on the passanger side - massive bottle neck...
GT - sm1thy1983
All the cods (except bops1 because it makes me rage)
F1 2011 - F1 2012
spray them when new?
not a fan of the yellow tints on your headlights, but other than that - Stunning :thumbup:
my bad (its been a while) [B)]
:no: only live when ignition is on
i have a AYP block sat on a pallet in my garage with 67k on it :)
Seriously though, better buying a complete doner car, stripping it down and...
haha, quality stuff :thumbup:
few minutes further down from wrexham and you would be on horse shoe pass - pretty similar to snake pass near sheffield - good road ! (near...
unplumb the valves but leave the electrics plugged in - extend the wiring and move the valves to hide behind the scuttle panel
iv heard of...