Separate names with a comma.
Front wishbones, rear bush.
Oil seeping past the thrust bearings in the turbo. When on idle there is not enough pressure to keep the bearing sealed. Apparently. I had the...
Its a fairly big job. You need a good size cable and a lot of patience for the wiring. I ended up putting the fuse box in the glove box so i could...
I had this issue. Fairly common.
Thrust bearing in turbo lets oil through into the exhaust, when there is no boost pressure, on idle. I sent my...
Claim its a cosmetic enhancement, he wont know its bigger than standard.
It looks like the vent for the EVAP or Charcoal Canister. It should poke through into the wheel well.
If you unbolt the canister the pipe will...
make sure all banjo bolts are tight and have the correct washers in, last thing you want to do is take it out again. Try and put the coolant lines...
You need a large spline boss. I bought mine from Bulgarian eBay, bit of a punt but it paid off. Only £17 haha.
You might need a bearing puller to...
sump has a sealant type gasket. about £7 for a tube from Euro car parts.
probably best getting a whole new pick up pipe
Had mine at r-tech yesterday. Made 240hp and 287 lbs ft. Really happy with it.
Has anyone had any problems with clutches at that power ?
Fmic, decat turbo back, air filter, 007p, sfs TIP
Had my car mapped today, made 240 HP and 287 lbs ft. So I guess the cooler works :-)
Axle relocation plates, and no sorry
They were 18's
Front et 18, 8.5
Rear et 26, 9.5
But it wasn't perfect fitment
Your struts will fit exactly the same
This is as close as I got, it's a few mm of laying frame.
I drilled my cast wishbones and bolted an angle to it. This allowed me to run with the r32 roll bar, but I used some audi A6 drop links, it was...
Past the halfway point with wrapping this yellow turd
Will help you get a bit lower, stop the subframe clash
I relocated the fuse box to the glove box. Means that there is no need to route that massive cable through the fire wall.