Separate names with a comma.
Yeah its accesable easily on a pd150 with the inlet and cooler removed.
Look good but not really needed unless big power.
Polo 6n topmounts apparently sit 10mm lower.
I have the polybush above fitted to my car, and it was barely noticeable. They clunk a bit on full...
Might need a notch, I do.
Change the arb, jom drop links don't work.
As for heating and bending you have ruined the structural integrity and torsion of your current bar....
I have one. Works well.
Exactly the same on my car, I just used a piece of flat bar wrapped it round the exhaust and old mount and welded it in the original position. The...
They do look pretty worn.
Is your car lowered? Even on max adjustment I'm still running negative camber.
Can of lighter gas to freeze it.
Remove the seat and do it outside.
Had the tracking done?
Definatly not fittted for the purpose of noise. Will make a noticeable difference to the way the car drives.
Found a black rear view mirror in the scrappys.
Now to find the other 20 odd bits.
Wheels can always be spaced out.
I have 7.5 et30 on the front and 8.5 et45 on the rear.
Going to put a 20mm spacer on the rear so it pokes some...
It's the plastic side tray .
Should have a wee torque screw through that hole you can see into the subframe.
Mk1 for me.
That's fookin horrible. Not a massive fan of the .:R its not a v6 any more.
What's the offset of the wheels?
Will be stamped ET??.
Unsure of the brand but a few guys on here have them.
But yeah that is a toledo.
They are toms racing wheels, no idea of the model.
Have found 2 sets one in the Philippines the other in Sydney.