Separate names with a comma.
Thinking about going for stage 2 remap.
So far the mods I have are as follows:
Aluminium bigger smic
All silicon boost pipes
I had a remap recently and I'm not sure if my torque figures are as good as they should be.
I'm running 211bhp 220lb/ft torque. 21psi boost
I'm struggling to get some studs and nuts for the turbo to cat.
Two bolts have managed to fall out and it's blowing badly.
I need to...
I have replaced all four coilpacks and checked all vac pipes.
I have a missfire on cylinder 4.
I replaced the coils because i was getting...
I have had my car in at a tuning company that managed to get my car up to 200hp but they said the ecu was safeguarding the engine every now and...
I have a code for multiple missfires.
New maf a month ago (bosch)
Various other parts.
Will this be coilpacks as its down...
Got my car remapped and fixed as it wasnt boosting correctly.
Turbo to manifold gasket was knackered and n75.
It is now chugging on idle sounds...
I have been trying to diagnose my car for a number of months now and finally decided a tuning company can have a go.
I supplied them with alot...
I have replaced all boost pipes with silicon hoses.
I have also replaced the MAF, MAP, Diverter valve.
I have also replaced the intercooler...
Anyone know of a mod i can do to get rid of the stupid metal push in connector on the boost pipe after the hard metal pipes after the turbo?...
I have the full vag com system so if anyone in the west Yorkshire area need a hand reading anything let me know.
Im still getting to grips with...
I fitted a new maf (bosch).
As when it was unplugged it drove and boosted so much better.
Would the next thing to look at a boost leak?
I have been looking into my terrible power issue.
When i bought it all was well.
Then about a month later it just seemed to lose its power above...
Just got my vag com and got the p0011 code.
Had my timing belt done around a month ago but only just scanned my codes as i have had the...
Sorry if this is a stupid question.
I have the auq engine 1.8t do they have an egr valve?
if so were are they located?
I'm getting a fault code for the sai.
does anyone know were to get one without it costing a fortune?
If not Can anyone...
can anyone help me.
behind the drivers seat it is wet through.
had a look at the seal and it looks ok.
anyone had a similar problem and...
Does anyone know the code for my turbo.
Its a mk1 cupra 180 02 plate
For about a week i have had an issue with my 180 leon.
When the turbo spools up at any revs it makes a strange noise.
Im doubting its the...
My temperature for the cooling system on the dial is on and off.
Every now and then when im sat in traffic it comes back on to 90.
Its had a new...