Separate names with a comma.
Leon FR 05 at 201k bought at 167k in 2013.
Has the car got any kind of tuning box fitted? I have found in the past that it can screw with the engine when it's really cold like it is at the...
Before you go ahead and replace the turbo it's not necessarily the vnt mech, as others have mentioned above, the engine will not...
As we all may have experienced the PD150 engine has a known issue with camshaft wear.
I'm going to be purchasing a new cylinder head, and...
Dan, No changes to the map as of yet.
Sure I can send you the last map that was done, can you PM me an email address to send it to?
Ah that explains it! Thanks Adam.
I thought for the hell of it I would buy a torque wrench today and attempt to adjust the syncro angle as it was fluctuating around -1.1 to -1.7,...
Who is Melett and where can I purchase?
Thanks, any idea where the cheapest place for a new pd150 turbo would be?
I should just go back to a bog standard PD150 turbo?
Tbh I wish I had never gone down the hybrid route now, very put off.
Ok I thought it was time for an update.
I have performed a mr muscle turbo clean on the turbo vanes and just last night did a diesel purge with...
Thanks Dan, I was going to try going back to the standard map and see if duty cycle goes back to normal, may have to start from scratch on the...
Might need to lengthen the actuator...whoops
Group B: '008
Engine speed IQ driver's req IQ via rpm(Torq) IQ via MAF
TIME 2850-3150 65-70 52-54 52-60
STAMP /min mg/R mg/R mg/R
Group A: '011
Engine speed Spec. intake press. Actual intake press. D.cycle MAP
TIME 2850-3150 2300-2600 2200-2800 35-80%
Turborevs aftermarket SMIC was used in this setup, hope that helps! :)
Thanks for that.
What would normally cause duty cycle to fluctuate so much? Just one day it started doing this and hasn't been the same...