Separate names with a comma.
Mapper drove it and said it felt fine to him, its deffo been more prominent since the map
dq250? is yours the 300 without the gpf.
gearbox oil change 4k miles ago, dsg reset etc. mine is the dq250, ive been in a dq381 cupra and it did feel smoother.
mine is mapped, clutch...
Has anyone else noticed that especially in sports mode when the car is dropping down gears in automatic mode, mostly 3-2 2-1 that the car seems to...
So... it only happens when going from drive to neutral and it only happens when the engine is fully on, doesn't occur with just ignition on.
Can anyone shed some light on this cupra 280 dsg, started happening tonight, hopefully nothing major
Doesn’t make sense that though surely because what other gear would I go into from 1st
Unicorn motor development map, my rev limit has been changed, kick down in manual mode removed, auto shift manual mode removed, just the usual...
Last night it happened in 1st-2nd too, only happens in manual mode, I wasn’t watching the revs but I go over Atleast 2.5k before pressing the...
ive noticed this recently that if I’m in automatic mode and I switch to manual while In 2nd gear and 2nd gear only, and then try switch up with...
Gonna get this booked in, the car feels awful at high speeds, the steering wheel is way too light, I darent even go round a sharp bend fast
One of them has gone now, I did do some coding and then tried to change the values but they stayed, the brake code has gone now after taking the...
U112200 brake (03) fault code implausible
U112100 parking assistance unit 76
I’m assuming these are linked but can’t figure out the issue, any help?
All that needed doing as I suspected was the angle sensor, just needed recalibration and everything worked again.
all sorted people, got it sorted at a specialist, £35 and everything is working again
I’ll go scan the car again, it’s along the lines of angle sensor error no basic settings, I’m assuming the park assist is linked to it? Because my...
When I try to do the calibration it doesn’t work, it doesn’t stop the calibration it just keeps going
Engine fully on
Tried mate but it won’t work
I’m praying sorting the steering angle sensor alone will bring everything back.