Hi all I’m looking for recommendations please!!
I have a cupra 180 and am looking for air intake heat shield and associated cold air feed pipe work, I was thinking of removing the front fogs and stick some kind of vent in?
TIA Paul
Sent from my iPhone using Tapatalk
No inlet charge pipe injector rail hoses etc, been gathering parts bit by bit so the missus don’t go mad with 1 big purchase [emoji2958][emoji6][emoji6][emoji2958]
Sent from my iPhone using Tapatalk
I’ve already got 3” cat back miltek, cone filter but looking at oversize tip and fmic with the bam inlet on to make routing easier!!
Sent from my iPhone using Tapatalk
Hi I have a 1.8t AUQ engine and would like to get a Phenolic inlet gasket does anyone know if my head would be small or large port?? or is there a way of telling without removing the inlet??
TIA
Paul
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.