ok so iv just replace the rear beam/axle bushes the top mounts and the dampers but the back end still feels lose going over a bump the back end still gives a wobble iv also got a rather bad knocking coming from the rear sound like the passanger side, its not the exhaust as the ends well before...
EPIC and totally speechless!!!!
I have just spent the past 5 hours been engrossed in reading the hole thread and nearly shed a tear when you were talking about scrapping it! your attention to detail is unreal and i can't be leave you done most of this on weekends!i will look forward to seeing...
Hi guys Iv got a flashing coil light it will start flashing after 5 or more minuets of driving if I havnt braked, as soon as I brake as I tap the brakes it stops flashing it will do it if the is been driven or sat still!
Iv done a search and all it comes up with to check brake lights which I...
i think there the same cooler arnt they? the only thing with changing the pipes is getting one that will fit the boost sensor in! iv been thinking on a spray set up but idealy i want water/meth kit to get temps down, going to pop over to autospeed and have a read
yeah going to do the full lot...
you doing the same thing im doing with 2 wires on the pump wiring? the stander coolers are ment to be good for 180bhp? there pretty thick though so that king of makes up for them been small! im going to get new wishbones, track rod ends drop links the lot really the bushes like the arb's and...
Oh and I didn't think the exhaust would fit! But I thought they may have been a chance that it would have! I need a new flexi pipe but I think it's part of the cat? Which would be getting chopped straight off!
It's not to bad I got confused on getting rid of the egr so Iv blocked all 3 pipes! Going to put some blacking plates on too! Iv got something to try that's similar to a Tunning box but it's not! And I have control of it bargain at £2 and I need to hunt for some injectors! Iv seen a Intercooler...
i think the red wire is to light all 4 lights when flashing main beam or switching to main beam? im just wiring mine directly to the plugs on the car i dont see why a relay is needed
Mine looks like the hex com h,I think I my have found the problem, there's a few dodgy wires behind the fuse borad and 2 plugs arnt plugged in! But I cart see we're they go
Hi all Iv tried vag-com and the garages snap on scanner and nither will coneyc to the ecu, any got any ideas why?
Car is a 98 seat Cordoba vario tdi engine code is AHU
carnt seem to get vagcom or snap on scanner to connect to the ecu so i think it fried car is starting an kicking in as though the immobilizer is kicking in! iv changed the 109 relay, and was thinking on trying the 103?
my car is a AHU and was wondering if a AGR ecu would work on my car? as i think mine has died from what i gather the AGR is a 90bhp the same as my AHU what are the differences?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.