Search results

Hello, Here is my little cupra....Cupra 280 DSG 2015 So : Motor: vwr600 CTS catless home made cat-back with valve Trottle pipe CTS Charge pipe CTS Turbo intlet TTE pouley CTS TTE470 Snow perf WMI stg2 IKH24 sparkplug Chassis : Kwv3 clubsport front and rear anti roll...

Some new ? Think we need a original vcds cable like 14. Version...

Ok I see. But I don't know because I know the turbo is a little bigger as the gti's turbo. Is the outlet is the same that is ok!

Hello, Someone know if the down pipe of a golf 7 gti fit on the leon cupra 280? I can't found any informations... Thanks !

So and what about the performance pack? They say in jully, but allways nothing...

Hey someone can tell me, if the motor of the 280 cupra is the same, that the s3 8v and the golf 7r ? Thanks

Hi all. Can I put the top rear with bilstein b14?

You have to change the spring of your forge 007.

I have i new ecu. And still have the problem ...

yes, but when i can't start it, i can't communicat with the calculator too...

I Will try to change it. Tank you. But were is it?

Hello. I have a problem with my seat ibiza cupra y 2001. My car starts but if I turn it off, I can't start it for about 30 minutes. The calculator is new. Not fault code... Help plz =(

Yes, I think I need to clamp a little the WG and see. But the injector can be the probleme ? I think 385cc can hold 1.1-2 bar at 6000 right ? Or need a FPR 4bar ?

so, first map, done 245HP and 420 NM. But, I just have 0.8bar at 6000, this turbo can have 1.2 at 6000 right ? So what probleme can I have ? Injector ?

Ok, thx you a lot ! One more question, how many HP can I hope, with my set up ? And, what aboute boost? stabilized boost ? and at 6000 ?

yes, my fuel pump is old. I have the remap tomorrow. what is a 3 inch maf ? S3 maf ?

Hello, I Have some questions. I have: K04-01 Manifold kinneticmotorsport 380cc s3 injector intercooler K&N forge WG Cat back milltek And I would like to know, if i need a FPR 4 bar ? Someone have it, someone don't have it. What can I change for fiability ? Tanks

Yes but i was too lean without it. I have a map with 1.2 boost and 0.9 at 6000. Do you think the probleme is too munch fuel? The n75 is correctly fitted and I have try with a other. Tanks

Yes for the vag com I had one default. Like eprom internal error. I had delet it and it did not return but the problem still. I dont have secondary air injection but I still have the valve on the motor. Can I have leak on it ?

Hello Here is the problem. The turbo charging, but it cuts to 4000 and gives no more than 0.3 0.1 or 0. My system does not leak I have put in 1 bar but after the turbo. I have change the n75 and the MAF. Still not change. I dont have try to change the DV. I have a k04 01 rp turbo with...