Search results

For those that are interested thought id start a thread for the new whip.. Cupra is currently sat nearly bare and looking sorry for itself on the driveway. Picked up a Supra in December Its an SZ-R edition so has loads of extras like Torsen LSD, folding mirrors electric seats etc etc...

Anyone know how to adjust headlight aim on cupras? Is it the big white screw thing on the back of the headlight? Tried using the little dial inside the car but it didnt change the aim at all :shrug:

Spent the day freeing a siezed piston in my brembos but one of the outer dust seals has a split round it Does anyone know any info on where to buy a new one? Just found a thread saying that LCR and ICR dust seals are exactly the same Can anyone confirm the sizes as being 36mm and 40mm??

16804/P0420/001056 - Catalyst System; Bank 1: Efficiency Below Threshold Anyone experienced this code can you tell me what the problem was? Its been popping up for the last 2 months now, i had the car mot'd 3 weeks ago where it succesfully passed emmisions test so it cant be my sports cat...

Fitting big brakes soon so will be adding new fluid Does anyone know how much fluid is needed for a full change so i know how much to buy?

Does anyone know the internal diameter of the lower header tank hose? (the larger of the 2 which goes to the block) Mine is in a bad way from previously rubbing on a jubilee so im going to buy some silicone to make a new one. Or anyone whos breaking a cupra right now could you measure the...

Having a few problems with brakes over the last few days My pedal seems to have a fair amount of travel before the brakes kick in... Also when i brake i can feel the pedal vibrating/ shaking under my foot. Lastly i can hear them scraping when i turn into junctions etc... My last 2 sets of...

Anyone here using the Black Forest Industries engine mounts? If so where did you get them from? Looked on the website but seems they only use ground shipping in America and dont send overseas. Or does anyone know any UK suppliers of these?

After fiddling around today ive noticed fresh oil all round the end of the tip where it goes onto the turbo inlet. Pulled the tip off the turbo and there is a small puddle of oil sat inside Any ideas if this is serious or not? I have a catch tank fitted so no oil is going back into the...

Does anyone know how to remove the full grille section from the bumper? VagCat list the grille piece as a seperate part, i can see the clip parts which hold it on but some of them look like they are melted, looks like its been done to fix the two pieces together Is it possible to remove...

Fitted the Forge Unos manual controller yesterday Was advised to replace the n75 with this instead of running them both together Now ive noticed the car has started overboosting Very crazy boost low down, just wants to chuck stupid amounts of boost in at a few mm of throttle, very loud...

Right so tonight i fitted my new OMP wheel, all went well and old wheel is off easy enough First question How have people wired the horn in? The standard horn is built into the steering wheel and there are no wires remaining for me to use lol Second question (very n00bish Question but want to...

I have been looking at the above.. Are these easy to adjust? Meaning if i had the boost turned down and wanted to turn it back up, it wouldnt allow me to go higher than the ecu is set at no matter how much i adjusted it? Cant be bothered with limp mode problems or anything lol And looking at...

Had a few requests for this and a few pm messages so ive mashed this quick guide together Ive seen some people buy all the cables etc seperate, but i found it alot cheaper to buy an amp wiring kit as everything is there that you need My guide is based on using 0AWG cable, and an alloy battery...

Noticed the last few days the TCS light is permanantly on on my car The button does not seem to turn it off or do anything for that matter Scanned with VCDS today and the only code was 18048 P1640 Internal Contr.Module (EEPROM) Error (After reding Ross TEch site, this code could be because my...

Noticed this club doesnt seem to do many club stands at car shows.... Can members arrange a club stand for the club at certain events? Or is it something admins, mods must do?

Going to be buying one of those turbo revs 3" downpipes for when i replace my manifold. Does anyone know what sort of lambda spacer i need for the second lambda?? Link?

Had this problem for a few weeks now If i start the car from cold, the first 2 or 3 gear changes i get a loud flutter from the turbo After that its fine and i hear my 007p in action Literally does it for the first ten seconds of driving from cold and then after its fine (Doesnt matter how...

Basically im looking at getting some suspension more suited for track driving Not paying 1k odd for KW and ive been looking at weitec coilovers. On another note ive seen the H&R shock and spring setups availible, anybody used these? Just wanting to know if theres some spring/shock combos...

I know this should probably be in the insurance section but im aiming this at you MK3 Cupra boys so posting here. Its renewal time again and ive heard good things about brentacre, i like the way they insure mods and power upgrades mainly with bhp limits and no costs for other mods etc...