Search results

hi all anyone with vag-com around the mid wales shropshire area? want sai and n75 etc getting rid of cheers.

et41 on all 5 wheels of mine

et 41 on all 5 wheels of mine

could be a cracked abs ring if halfrauds buggered about with bits. check the code on the net should tell you which corner the abs is playing up.

hi all, changed the oil pressure switch last year and pickup pick as oil light flashing at me. happened again couple of days ago so changed the switch again. as i turned the car over two small plooms of smoke came out of the engine bay which seemed to be one from the newly installed switch...

How much bhp and torque can they withstand?

hi all, does anyone know of the best clutch and flywheel combination for mk4 cupra 1.8t? thanks

Hi all, does anyone know if the turbo inlet pipe from creation motorsport is anygood? it looks good quality and a hell of alot cheaper than the forge one. thanks

learn something everyday, and saved me some money. by the way how long can a 1.8t engine last miles wise? cheers

what about an AGU with ko3s turbo?

has anyone tried fitting a BAM engine and 6 speed box into a mk4 cupra? thanks

anybody had any problems with the rear dampers on the JOM coilover kit?

hi all, probably been asked before what are the best plugs and coils for the mk4 cupra as mine has just started missfireing between 2500 - 3000 revs thanks

cheers buddy!

any ideas were to get the kit from and a guide to do it?

did have a look and to be honest it did look like the cv joint most of the oil/grease was on the boot. was hoping it was that just had new coilovers!

took my front drivers side alloy off today and found thick oil/grease on the inside of the alloy and on the brake caliper an cv joint. what would be leaking? cv joint, damper or brakes? thanks

cheers mate, new to suspension modding!

i have , but the cup that the spring sits on is to stiff to turn with the spanner they give you.

definatly better not to stiff and not to soft steering is slightly stiffer to. the rear is still a tad to high and i cant get the cups to go down with the supplied spanner any ideas?