Search results

Hi all. It's a long long time since I've been on here but I was wondering if anyone knew what happen to my old cupra. I HPI'd it the other day to find it was stolen on 30.12.2009 and a insurance claim was made in LEICESTERSHIRE. Was it ever found? Many thanks Matt.

As far as the oil in coolant goes, i think it will be the oil cooler leaking. Quite common, especially if there are no other problems with the engine. As far as your engine build goes, give me a shout regarding torque settings, procedures and part numbers as i have Elsa and Etka on my...

Not sure about where else you can get them, but here is the part number. 002 517 185A you will need 2 of them, these include the races. Around £ 20 each Remember you will need a selection of shims aswell. Matt

Part number from Seat is 056 129 971. Matt

With the correct workshop equipment they can be done without removing the head. But most dont have this equipment, so cylinder head removal will probably be required.

No pictures of it Bill, just what he said to me via email, one half of the collets was in 2 pieces. More likely to be a retainer though? or spring?

Yeah my old car. Valves are supertech, jamie says a collet has split in half. I thought over rev too. He is rebuilding it with New JE pistons, new valves, double springs and Ti retainers. So should be good for mega revs. I never ever revved it above 7.5 K

This a cupra R or cupra? Looks like it could be oil temp or pressure switch wire.

1 - Breather pipe q From gravity valve on fuel tank 2 - Activated charcoal filter q With solenoid valve 1 for activated charcoal filter -N80- 3 - Turbocharger 4 - Pressure unit q For charge pressure control valve 5 - Non-return valve q For activated charcoal...

N90801101 LOCKING PIN N01152318 WASHER N10117403 BOLT HEX SOCKET 6N0609657A BRACKET - bracket to hold handbrake cable on MK3 with drum brakes N90484003 SCREW HEX HEAD 171823395 RETAINER - rubber mounting for bonnet stay 1HM121267 BRACKET - Goes on top of radiator on left (...

Not sure mate, they are high impedence ( 12 ohms ) if that helps?

Only by reading boost pressure through measured blocks can you tell if its remapped.

The part number 06A 906 031BC is the correct number for BAM / AMK injectors.

What year and engine code is your car, i will get you the part number.

Glad you like mate. I love that car.

6k0 807 221r gru

Upper belt cover 06a 109 108 h

You will need to remove the Sheild to fit the Ibiza 305mm disc.

If you guys have a request PM me, i will do my best to get back to you asap. I have full access to Audi,VW,seat,Skoda numbers 24 hours a day. Try and include full model and engine code or trim colour where appropriate. Please be patient though. Thanks

6k6 807 441d gru £5.08+vat