Search results

  1. halsall1987

    Bonnet bra

    Hi everyone, I've had a look around for bonnet bra's for the mk3 but can't find anything. Does anyone know of any being sold, or the company likely to manufacture them first? Thanks
  2. halsall1987

    1.4 TSi ACT 150 - on order!

    Hi all, I've been a member on SC.net for a few years having owned a MK1 Leon Cupra, but have just ordered a new 1.4 TSi ACT FR this week! :funk: Decided to wait until 1st Sept though for the 64 reg :) The dealer explained that they are moving to the ACT as of 1st July to replace all...
  3. halsall1987

    Re-fitting standard Aura headunit

    I'm taking my Leon back to standard including head unit, but I can't remember if the stock Aura headunit came in a cage as it doesn't 'hold' onto anything when I push it in? The cage for the JVC headunit I had is too small for the Aura. Thanks
  4. halsall1987

    Engine rattles on idle start up (Video inc)

    Very recently when I've started the car up and left it to warm up for a minute or so, it feels like the whole engine vibrates and rattles. It isn't constant, or at any particular rev range. If I blip the throttle it goes away, and does not happen whilst I am driving. I have had a...
  5. halsall1987

    Clutch pedal sticking down

    When it's cold out (like this morning) as I drive off my clutch pedal doesn't return up. I have to hook my foot under the pedal and pull it back up, then its fine after that. It's as if the fluid isn't going round the system properly? Any ideas?
  6. halsall1987

    C-C Stage 1 Results...

    I'm just gonna put the graph up [B)] What do you all think? The car started suffering from the heat in the garage by the end run, not great ventilation so the figures started dropping fast! Pleased with the outcome though. Was advised to get a new N75 valve due to fluctuating boost.
  7. halsall1987

    Remap next week, few questions...

    I have been looking at a Jabba stage 1 from J-Tech in Reading (near me), who quoted me £275 inc VAT for the software but the don't have a rolling road... :blink: Just spoke to MidlandVW who do Custom-Code remaps and been quoted £275 inc VAT for software AND before/after dyno runs... which is...
  8. halsall1987

    Have I done the N249 bypass right?

    Took 15 minutes out of my busy schedule to do it. :rofl: The reason I'm asking if its OK is because I have put the t-piece there so when my gauge pillar comes from Nomad I plan to use an x-piece to run the boost gauge hose across the fuel rail and into the car to keep it neat. I just...
  9. halsall1987

    Found a split pipe - but what pipe is it?

    Pics say it all, was having a nosey around my bay in preparation for my TIP which I just ordered and spotted it. What does it do? Is it important? Can I buy a replacement and change it myself?
  10. halsall1987

    'Cuprice' - My MK1 Leon Cupra 1.8T

    So here she is... 52 reg with 56,000 miles. Full Seat main dealer/VAG specialist service history. Traded in my old Hyundai Coupe 2.0 which I had for a couple of years, so went for something a bit more tuneable! :D Not planning to do much exterior work - maybe lowered and some tints...
  11. halsall1987

    Dump at low boost?

    Just fitted my Jetex filter on my LC last night - went for the 80mm and reducer :) Sounds awesome - turbo spool and dv, but the dump is quite loud, even at low boost when I'm just moving in traffic. Is it normal to have blow off at such low boost?
  12. halsall1987

    Which mods to go for?

    Hi everyone, first time post as I've only had my LC for two days now :D well happy with it! And the forum is awesome ;) After much searching on the forums, I've got a bit of a wish list: Jetex blue cone filter Forge 007p valve Silicone TIP* Custom cat-back exhaust* Stage 1 re-map (after...
SEATCUPRA.NET Forum merchandise