Search results

  1. conorc

    Conor's mk3 Ibiza Cupra R

    Thanks mate yea its been a busy few weeks with the car! Got the splitter off eBay but I'm pretty sure a local seat dealer sells them slightly cheaper! Here's the link to where I bought mine: http://m.ebay.co.uk/itm/221123751852
  2. conorc

    Conor's mk3 Ibiza Cupra R

    So I've been very busy with the car lately, heres a list of what I've done: Carbon coated mirror caps Carbon front upper strut brace Carbon nomad pillar gauge carbon S3 inlet manifold trim Stainless rear strut brace fitted forge Turbo intake pipe (what a b***h of a job) new red silicone...
  3. conorc

    Conor's mk3 Ibiza Cupra R

    Haven't updated this in quite a while, basically got back from Australia for a few weeks over christmas, so could finally begin working on the car and fitting the mountain of parts waiting for me! picked these up at a reasonable price - should be arriving in the next week or so... BBS CH...
  4. conorc

    intercooler to inlet manifold pipework?

    Cool thanks chambers will get that ordered :-)
  5. conorc

    intercooler to inlet manifold pipework?

    hey I currently have what seems to be a toyosports FMIC with 2.25" piping, I'm wanting to extend the pipework up to the inlet manifold as it currently connects to standard hoses in the bottom right hand corner of the bumper. Does anyone know off hand which pipes/connections I will need in...
  6. conorc

    Ibiza cupra ABS LIGHT

    Thanks guys, turned out to be faulty wiring to the sensor so I got it sorted in the end! Thanks
  7. conorc

    Ibiza cupra ABS LIGHT

    Maf sensor really? How could that affect the abs?
  8. conorc

    Ibiza cupra ABS LIGHT

    Shouldn't be a faulty sensor as the light went off with obd scanner immediately after fitting. Anyone know if it could be a fuse issue? Where would the fuse be located? Also should the sensor constantly touch the abs ring or should there be a gap?
  9. conorc

    Ibiza cupra ABS LIGHT

    just to add- when I erase the fault on OBD Scanner, the ABS Light goes out for a split second, then comes back on again.
  10. conorc

    Ibiza cupra ABS LIGHT

    hey guys, My ABS & TC light are currently on, I've replaced both front sensors, which seemed to clear the fault for a short period of time (a few hours not driving) then its come back on again, OBD Reader says its the front left ABS. Any other ideas on what this could be? I've got my MOT...
  11. conorc

    Cupra wheel bolts

    no mate they're a set of BBS I bought from cupraelliot off the forum. I'm not home for another week so I can't check them to see what bolts are going to suit just yet :-(
  12. conorc

    Cupra wheel bolts

    do you sell these bill? if so how much?
  13. conorc

    Cupra wheel bolts

    thanks guys, Ive tried those stud covers before, not a huge fan of them.. with regards to a stud conversion I assumed it the studs would need welded at the back? thanks
  14. conorc

    Cupra wheel bolts

    Stud conversion is a good sughestion but its way to much effort, and I think painting them will be destroyed as soon as I put a socket on them to fit them! Tried a couple of jap sites like drift works etc but all seem to be nuts rather than bolts on sale!
  15. conorc

    Cupra wheel bolts

    doubt they'll sell black bolts mate
  16. conorc

    Cupra wheel bolts

    Hey just wondering where all of you have got replacement wheel bolts from? I'm looking to get a black set but seem hard to come across a decent quality set. I know they are m12 x 1.5 but the only place I seem to be able to find any is on ebay which don't look the best of quality! thanks
  17. conorc

    Ibiza CupraR Brake setup

    cheers lads, yea from what I can see brembo disks & pads arent cheap :( oh well has to be done. what about braided lines? worth the extra money?
  18. conorc

    Ibiza CupraR Brake setup

    Hey guys, I'm going to be replacing my disks / pads all round within the next month, what disks & pads are most of you going for on the rear and also anyone with a brembo setup on the front... I don't want to spend huge money either! :) any help is much appreciated! Also anyone using braided...
  19. conorc

    Conor's mk3 Ibiza Cupra R

    Bit of a revival, the cupra is still sitting covered up back home, I'm due back for 6 weeks at Christmas so I've started purchasing bits and pieces for the car already. Obviously the main plan is get it through the mot immediately, then hopefully build the spec up a bit for a trip to the...
  20. conorc

    turbo advice

    Thanks guys, I didn't realise I'd need so much to run the hybrid, the car has already been mapped and has a fair few mods, I think ill look at just going for a k03s for now. Won't need that much more, would get it mapped again also. Thanks! :-)
Progressive Parts, performance parts and tuning specialists