Hi peeps,
In the process of during a few mods and the main thing bothering me is how poor the fr seats are. Has anyone fitted or experience if mk2 leon fr seats can be fitted into the mk4 fr. Ive seen a fabia vrs online with them fitted, but feedback would be helpful.
If I where you I would keep it and give it a bit tlc mate. You have spent a lot of money on it and u won't get it back as of yet. I wanted one of these mk3 cupras ever since I worked for seat back in the day. I ended up with a mk4 fr tdi. Couldn't find one good at the time.
Seen mine up for...
Looks sweet! What's your exhaust like? Is it noisey or just right?. I've got standard exhaust, just gonna chop n weld the centre silencer up at weekend. Hopefully be just enough
Is your clutch ok with the extra bhp? Drive mine like miss daisy until warmed up. Never gets tortured however a bit weekend fun in it is what am looking for.
Hi
Anybody had there cupra mapped to around 196bhp ish?. Reason being I can get mine to around this with local specialist for about £180. Was gonna get miltek cat back but the remap is cheaper?.
Any feedback?
Just put a deposit on mine at £2900, it's mint condition y reg. Theres one on eBay £5k sitting around 310bhp. What's the K03s? The links removed on guide.
Been reading a bit in depth with regards to suspension on the mk4 ibiza. I find the standard suspension pants!. By this it's strange I.e crashes,bangs on slightest pot hole which is really getting to me! Drove to Harrogate at the weekend didn't find it that bad but 3 major things gripe me...
Stay away from Mohawk tyres, got x3 falken ze914 Eco runs on and they are champion. Good thick quality side walled tyre unlike the remaining Mohawk tyre. Was tempted with rainsports 2 but got a better deal on camskill.
Have you got a vag obd scanner? This will narrow the fault down. I had the same problem since the bad weather.O/s/f abs sensor harness had rubbed against the strut and split wires. I cut wires, and soldered new section in and shrink wrapped.
As for your intercooler pipes mine have moisture...
I priced these up at £3.61 inc vat each from pulman seat which was no bad. What torque settings do would you advise for the nuts. 50nm 45 degrees of a turn further?.
Hi
Cheers for the replies guys, just checked autodata technical book states 50nm + 45 degrees more of a turn. Dealers stated the same, I. Order two new nuts as piece of mind and retorque on pay day. In the mean time ill Carry a 36mm socket and powerbar in me boot.
Hi
Has anybody had any issues with driveshaft hub nuts coming loose?. Noticed I had a knocking/clunking noise from o/s/f wheel yesterday. Got the car jacked up and removed plastic hub cap and the 36mm hub nut fell out!. Checked everything over driveshaft/ hub etc and splines fine. When I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.