i have done the research and i think all i need is a downpipe. all the common problems have been done
maf meter
temp sensor
coil plugs been changed to the newer type fsi one and adaptors with new plugs
sump has been removed and oil strainer was cleaned
the pcv has been removed and new...
as said im game. will be good to see a few cars there like. we dont need to make it too early tho as i will probably be hungover to sh!t :P and also im hoping its not raining too as it will dirty my car lol.
garage door rubber seal. some people on here have done it. but it only really works on the fr bumper as the cupra one ( or mine anyways ) dont have a full smooth lip under the bumper so i think it may look a bit sh!t with a gap in the middle if i put one on my car.
Ok so after a long day cleaning from 9am until 6pm the car is lovely and clean inside and out. i ordered new mats for it as the original ones are still in there and have holes in.
here is a photo of before the clean.
then after a shampoo , clay bar , polish then wax looks like this
I...
i have been doing some mpg hunting today and averaged this over 57 miles
not bad considering its remapped to 199bhp and 346lbs. loads of work been done lately. Its had a decat , and remap at r tech. I have taken a gamble and wrapped the fogs in yellow vinyl. Today as long as the weather holds...
the steering wheel needs a full turn one way or another. i had this on my golf. its simple to do. one 13mm nut at bottom of steering shaft. undo it and disconnect the knuckle and do one turn one way if that dont work turn it 2 turns the other way.
as jreedy said when you lower the car with axel rear beam or independent suspension u will create more negative camber and also bring the wheels forward slightly causing the tracking to be all over the shop. you can buy kits to get the rear wheels sitting central again too. how long before you...
its over tensioned. maybe it will stretch a little but i wouldnt be happy with it. it may be fitted at a wonk and cam rub on timing belt covers. causing the belt to fail. with out hearing the noise its hard to tell. but it shouldnt really make a noise. As a diesel fitter i have never had a...
i had h7 before and they was all over the shop and fitted correctly, i tried setting them on a beam setter and had no luck again. i bought orsam night breaker bulbs. really good bulbs and dont look chav.
that's what i done in the end mate:) but it came the wrong colour. came black and i needed the lighter coloured one ( not sure of the name) but i went to halfords and bought spray to match. easy enough :) cheers for reply tho.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.