Search results

I ask my question in this topic! Today I used emcs function to switch back to "normal" mode. I have only stage 1+ map (ron 98 octane) and normal map. So have U guys tried to use "normal" map after remapping because left foot braking is still working in my car...

Same problem here, torque 481 Nm. Tyres are 235/40/18 Michelin Pilot Sport 4. Below 15 degrees (Celsius) u can easily leave black marks to road in 3rd gear when turbo spools up. It is really hard to launch car properly, sometimes bouncing starts suddenly and then u have to back off and next...

My faults are here checked with my own vcds. "Vag-specialist" used some professional "bosch" software and hardware and he said that my problem is wiring harness. He also said that he have changed dozens of wiring looms with same problem. Same age Vw Passat and Audi A4 have same problems 2...

Same problem here since June 2014. It says "check dipped beam left and right". Every time I turn xenons on that dash light turns on. All lights work properly and even those turning bi-xenons work (afs-lights or something like that). Problem is located in lighting harness in both sides. It so...

I use SONAX Chrome & Aluminum Paste

I sold my 19" oem Ronal Potenzas with 220€. Selling took almost 2 years here in Finland but finally some guy bought them to Leon FR...

Oli change done with Motul 300V 5w-40 again after 4200km, checked Denso IK24 sparkplugs and compression test also done. +1000km roadtrip starts monday morning 04.00

Hello! Seat Leon mk3 5F -14 CJSA engine (1.8 tsi) with DSG Mileage: 89402km-55551mi First problem, car keeps throwing this fault code. Local vag garage says it can be wire problem. When you clear fault code U can drive many days without warning light, suddenly it appears again.... Any...

Back to the topic: I suggest to have proper engine and transmission mounts made by Revo or Volkswagen Racing. I would choose Wagner Tuning intercooler and proper Milltek tbe. Loba hpfp have produced zero problems so far.... Offtopic: Of course my numbers sounds crazy. Maf readings support dyno...

I have Loba hpfp, Volkswagen Racing intake, Milltek non-resonated catback and APR Stage 1+ map. Everything else is stock and my Leon produces over 390 bhp, no need for stage 2+. Daily driven car

Nice numbers with tsi engine. Are you still running oem spark plugs?

I started to use Motul 300v oil, no "mayo" effect anymore. I have lost 2-3dl coolant since timing belt and water pump replacement but still running fine.

I need to do "readers ride" topic but I will post this anyway APR Stage 1+ Loba Motorsport HPFP Volkswagen Racing Intake Milltek non-resonated catback Oem ngk spark plugs, Motul 300v oil only Stock clutch, intercooler, downpipe, catalyst and turbo No hard launches, roll racing is my...

Cupra R gave everything to dyno. Little issues with heatsoak, pcv valve and spark plugs. Watercooling and denso ik24 plugs should give easily +400hp :lol: Result was 394,6hp with apr stage 1+ map. Check out "spoolin shirley" channel in youtube to see dyno run https://youtu.be/38YOEx-zLBU

Bridgestone Adrenalin RE002 225/40/18 Extremly loud on daily use and fuel economy is bad. BUT great tyre for track use and suits for high power fwd. I drove six 20 minute session, wear was only 3-4mm in front wheels. I have 388bhp Leon

I just ordered Forge short shifter and new floor mats, finally.....

How did U put those seats in place? Driver and passenger Sparco seats. Did you use custom made rails or something else? I want proper seat also!

I changed winter tyres, studdless 225/40/18 :whistle:

With your modlist I expected much better results... Something is wrong I have Leon mk2 Cupra R (-10) with APR Stage 1+ software. My results are 388 BHP and 461 Nm (~340ft-lb). Now car runs extremely good:lol: Tested in MAHA dyno, all tests are made in same dyno. Stock result was 271 BHP & 347...

Great feedback from your trip! Any footage from autobahn?