Search results

You should have changed the wear sensor too. Once the warning light comes on (the disc has worn away the material of the sensor and broken the connector wire) , the right way to get rid of the light in the dash is replacing the wear sensor. This warning can also be permanently deactivated with...

Reset the comfort mode in windows. 1) Run window all the way down by holding switch in down position. Continue to hold switch in down position for two seconds after it reaches bottom. Release switch momentarily and hold it down again for two more seconds. 2) Run window all the way up by...

His battery is EFB type, having a 1.4 TSI engine. Upgrading to AGM would have been my choice, but it's okay!

Those cheap gadgets don't allow any modification. You'd need Carista, OBD11 or VagCom.

It's important to code it so that the system can start a new charging cycle (reset). If the new battery is like the original one, just a change of serial number would be enough.

You need to run a wire from outer indicator (pin 2) to the new inner one (pin 4). No coding needed.

FR: 50 mm ; Cupra: 55 mm .

To retrofit the USB port replacing the OEM Mitsumi module, you can follow this guideline below. Hope it will help you. ;) Parts 5G0 035 222E > USB+Aux module 8V0 035 750D > 6-pin HSD Connector (w/5v) 8K0 973 754 > 4-pin electric connector Pinout From old 16-pin Mitsumi connector to new 4-pin...

No need of a BCM update if you are only fitting the headlights.

Unfortunately, retrofitting facelift LEDs is much more complicated than just 2 adapters.

There are different sites where you can get them, though they are not cheap and are prepared to be used taking some wires to the BCM. If you get these ones, you would have to do a couple of changes (pin 10). No doubt you would save a lot of money if you create them by yourself. That's right.

Your doubts may be also the questions of other users. Let's share the information here. Thanks.

To fit pre-facelift headlights to your facelift Leon with no levelling, you don't need any wires or cancellers. Just pin adapters following the new pinout (see image bellow) and coding (the same coding required for a pre-facelift Leon). Greetings from the Canaries ;)

Considering you already have a High GW, you would have to replace connectors and the BCM. It's not impossible, but not easy either.

The codes LS9R, S9R, 2Y will give you the same colour: Blanco Nevada / Nevada White.

Check the connections in the blue connector. It's not the first time I see a black screen due to that problem. Enviado desde mi Mi 10 mediante Tapatalk

Yes, it's a dust cap. Just take it out and stick it on the spacer.

Some guys have had to remove the rear hub cap to make the spacers fit.

Well, looking for second hand parts and being a bit patient, everything is possible! I made the conversion for 800€, buying on eBay. Of course I found parts for the double price too, but I was in no rush.

Imagine spending £ 800-1000 in new led headlights to find the same condensation? That would definitely break your heart! https://www.seatcupra.net/forums/threads/slight-condensation-in-headlights.434136/