attached

Hi Guys, I've recently picked up a Bora 1.8T Sport with full Milltek (downpipe and cat recently replaced under warranty), Carbonio and APR Stage 2 software. It has the AUM engine which as you will know is exactly the same as the AUQ apart from the factory ECU mapping. Same turbo, DBW, VVT...

Hi there, Im getting a 7" in car DVD touch screen system for my 2004 SEAT ibiza 1.4 that replaces for old standard radio. I have spoke to Halfords and they said yes, it will fit with a harness adapter for an extra £12 which is all good. BUT, they did say if the radio unit is attached to the tray...

Hi all, I've had my X LC Sport (1.8T AUQ) since February and ever since I bought it (had 103,000 on the clock), its gone in to limp mode most mornings. Winter/Summer, doesn't matter. A few minutes of running later, and I can restart the engine and have full power again. I have the 'pressure...

Hi guys, Noticed this evening while at the petrol station with my wife's car, the Sill beneath the door has a deep scrape that has also dented the sill - about 8 - 9 inch in length. What would have to be done to fix this, can it somehow be straightened again? Whats the likely cost also...

Hi Guys, Wondering if you can help. I have a Leon Cupra 1.8T 180 with Performance Torque remap and seem to be having some boost (i think) problems. Around 3200rpm i can hear and feel a flat spot, the boost sounds like it drops, then comes back about 3800rpm. I think the same happens around...

Just as it says, I've been running this variable resistor in a box for around ten months and was going to remove it for MOT but did not have time . Thankfully it passed no worries and the box was never a smokey /ruff idle example. I am however gearing up for a remap when i can get the funds...

Hi Not had my 210 LCR for long and the front splitter keeps falling off at any given opportunity. How well attached should it be?? Went down a single lane country road at the weekend and the muddy line in the middle kept catching on the splitter and three quarters of it came off and it...

Hello all, I just finished installing the forge tip to my turbo and went for a drive to get a decent log of my boost (I only peaked at 12 psi with the turbo inlet included on the ATP kit so i went ahead and ordered the forge tip to try and solve the problem). Now the car peaks at 15 psi...

Advice - Logs attached - Updated results! Did 2 tonight logging 003,020 & 115 - running esso 97sul .. heres the results 1st one is a 3rd gear run Clicky 2nd is a 4th gear run Clicky Advice welcomed, I know the MAF is reading low but im concerned about the CF stablisation being...