circuit

was driving to work this morning nd a van followed me into the petrol station nd the guy said my reverse light was randomly flashing as i was driving along, thought it might go away but it has continued through the day. also realised my rear wiper has also been stuck on all the time even when...

Hello. I own a 1.6 16v Leon 1M 2002 BCB engine. After i disassembled the engine because it had 2 axial bearings damaged, i repaired the crankshaft because it was affected by the bearings, and i unjammed the pegs (i don't know if this is the term but the french is taquet) because some of...

Need to look at somthing if anyone can help! Random HID kit issue thats getting on me tits! Also any ideas how many amps can go through the lighting wiring without causing damage? need to upgrade the tiny 7.5 amp one again! (already put a 10a!) Thnx

Hello everyone, I drove to work this morning and got a light up on the dash, so had a look in my Scangauge to see what code was stored for the fault,it showed P1421 secondary air injection valve circuit short to ground is this code anything to worry about? And Im guessing maybe it would be a...

Croft Circuit have been served with an injunction limiting their motorsport activity to 40 days per year, due to a complaint about noise. This could be more bad news for BTCC. Details at the following link:http://www.thenorthernecho.co.uk/news/4076123.Croft_Circuit_loses_noise_appeal/

Can anyone help!! Just changed my plugs last week cuz they were misfireing then yesterday i was drivin home and it started to run on 3 cylinders so went and got 4 new coil packs and put them on now my engine warning light is on telling me these fault codes 17766 Cyl. 2, ignition circuit...

Hi guys, I have symptoms of what feels like boost cutting in and out between 2000rpm-4000rpm... So rather than throw money at it guessing I want to try and fault find by disabling parts of the boost circuit. N249 N75 Dump valve I want to try TEMPORARILY disabling each device in...

Hi all! I have a Cordoba late -99 (Almost -00) with the "new body". My rear upper breaklight (the leds) fail intermittently. Every now and then they stop working for a few days, and then they come on again. I havent found any wiering diagrams to look for connectors and stuff. Anyone...

I have the fault codes 17511 and 17524 which both relate to the heater circuit on the lambda sensor before the cat. Reading past threads, its a good idea to check the wiring and also the resistance in the circuit before shelling out on a new sensor. Has anyone done this before and can tell...

Hi, I own a 2002 Ibiza 1.4 Chill and my battery goes flat after approx 5hrs. I am guessing i have a short circuit somewhere but have no idea how to start looking. Yes i could put it into the garage but know it could cost a small fortune for what may be a simple problem to solve. The car is...

Need to change the clutch master cylinder on my LCR, doesn’t look to bad a job but I understand it’s a pig to bleed. :( Any advice would be appreciated.

Getting the above error in my A4 1.8T Sport. Does it mean the lamda is goosed? Im also getting no boost from the turbo but nothing other to suggest a problem. i did have N75 errors so replaced the valve and wiring to the valve which seemed to fix the n75 error but still no boost. Ive changed...

Anyone know what this error means? '53 LCR 225 - BAM engine. I have a bailey DV30 and jabbasport induction kit. car seems slightly down on power. :confused:

In a red Cupra R holding up the Westfields round the twisty bits? ;)

My engine light had been on since about 42K but since the car was running ok I waited until the 50K service to get it looked at. The Seat main dealer diagnosed fault code: 16502 P0118 035 Engine Coolant Temperature Circuit High They told me they thought it was a worn impellor on...

Got a few faults on the car. Sorted the MAF but can't seem to remove the Engine coolant temperature circuit sensor? I let the car cool down, took the first 'horse shaped' clip off that then allowed me to remove the sensor, now how do i unplug that sensor from the wiring to put my new...