hose

Can anyone explain to me where the small hose that comes off the top of the DV goes to? It's a Leon Cupra 20VT. I had to reverse my DV as the hose split just where it bends before meeting the DV nipple so I had to cut about an inch off the end of the hose. There wasn't enough length left in...

So, after reading a bit about turbo hoses popping off and mine popping off and now seeming to leak on full boost (feels a bit down / rough, more black smoke than usual). One part of the pipe has been replaced by local garage, but the other two thirds left alone (apparently the pipe is in 3...

When doing my under the bonnet checks last weekend i found that there was a coating of oil around the nearside boost hose (the one that goes from the intercooler to the throttle body). The car is revo'd stage one. Had a look around but there doesn;t seem to be oil on any other parts in the...

Can anyone tell me what size vacuum hose i would need to order to replace all stock? I think its 3 mm and 6mm

My car has been making strange noises. I took the air in take apart and to the right of the throttle housing is fine, to the left the big fat pipe that goes down to the intercooler has oil in it. Not lots but enough to make me think that is not corect? Any ideas how oil could get there and...

Hi all. The hose that goes in to the the TB.. Seems to be crimed the other end. Does this mean "Don't take me off", cause i want to replace it with a nice blue one but don't want to screw anything up. Not the best pic. but u can see the hose (currently back) Just left of the DV.

Hi all, Recently got a 2002 Ibiza 1.2. Might sound daft but it looks, to me, like there's a missing air intake hose, but not sure as haven't been able to compare it with any other ibizas and I'm no car expert. Basically just under the bonnet there's a couple of holes that seem like...

As per title, just wondering how everyone gets the hose to the gauge on the pillars without squashing it or kinking?

Hi all, I own a 98 Cordoba SX and have recently found a fraying hose under the bonnet. It's not too bad at the moment but have booked it in to the dealer to be replaced. A mechanic friend did tell me what the hose was called, but when it came to explaining to the dealer I had forgotten...

Hello! Has anyone here managed to run a boost gauge hose through the grommet on the drivers side of the car? (The one the bonnet release cable uses). In fact.. has anyone managed to run anything through that side? If not.. do the boost gauge manufacturers give you enough hose to get...

Hi all, fitted most of the hoses to my 52 plate LC but can't find where one of them goes, i've fitted all the wiggley ones, the short fat one and the big s-bend one but i can't see where the elbow hose goes, anyone know where it should go...

Afternoon people. Was just having a look around on ebay for s3 parts for my leon and cam accross this. http://cgi.ebay.com/ebaymotors/Audi-TT-225-S3-Silicone-Induction-intake-pipe-water_W0QQcmdZViewItemQQcategoryZ33601QQihZ002QQitemZ120147110025QQtcZphoto Its a TIP pipe for just over...

the hose circled red is looking worse for wear so gonna replace it wats it called/do? cheers

mine has a hole in and inside is nasty nasty nasty with oil and crustyness!!! part number 06A103221AH split is right on the corner of the hose that comes out of the top of the engine, Can i drive it even though ive wrapped around a shed load of PTFE tape and then insulation tape around...

need some for my boost gauge. it came with some crap stuff thats kinked and isnt working. what size do i need, 3mm, 5mm??? cheers

Ello All, I've just had my gearbox reconditioned and installed in a 2003 LCR. I foolishly didn't look under the bonnet before I took the car away as I was in a rush and had a long drive ahead. Short of the long. The hose that connects to the steering rack seems to be hanging around and...

I bought a metre of this and fitted some today but it feels crap compared to the forge or silconhose stuff...it seems too easy to squeese it together. http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=260130296489&ssPageName=STRK:MEWN:IT&ih=016 I wouldn't advise getting any. Do...

What would u prefer???? Which one has better flow??? :help:

Ok proberly a very quick answer from someone in the know, my k03s is on i just need to know what to do with the 2nd vac hose going to the actuator, ive spoken to m0rk and he thinks you just need to T it in to the other one, but ive searched and somebody else says you should block it off, so im a...

Having my LCR remapped very soon with revo i have just had the trail and loved it. I have brought myself the forge 007p DV on the advice from garage and forum but while on the forge website I saw that they sell a uprated silcone induction hose and the write up comments about the stock one...