mass

As the title says, dual mass or a single mass flywheel? just your opinions on the matter? which would you guy and girls go for? Cupra Tdi 54reg and upgrading with a sachs performance clutch.

Hey fellas 17705 - Pressure Drop between Turbo and Throttle Valve (check D.V.!) P1297 - 35-00 - - 17545 - Shareware Version. To Decode all DTCs P1137 - 35-10 - Please Register/Activate - Intermittent 17535 - Shareware Version. To Decode all DTCs P1127 - 35-10 - Please Register/Activate...

Heyya, Just noticed something weird yesterday, my revs started bouncing between 700'ish-1000... I read some posts on here and tried unplugging the Mass air flow sensor/meter and it seemed to have stopped it... My question is, are there any fitting guides? is this something i can do easily...

is £250 delivered a decent price for a sachs dual mass flywheel? going to get an up rated clutch on and from what i can see ill need a new flywheel due to it being bedded in with the old clutch disk , not going for a solid one as the cars a daily and dont want it vibrating like mad. is...

Just taken the box out of my Altea 2.0 TDI & I'm pretty sure the DMF is phucked! It seems to have end float, ie, you can seperate the two parts slightly - I don't think this should be happening!! So, suggestions for the best place (price) to get a replacement. Cheers.

Im on the case of my major fuel consuming 1.2, my mate says i should consider replacing the oxygen sensor and maybe the mass air flow sensor aswell incase they are not reading correctly and overfueling the car when not on full throttle, anyone know if the beezas have 1 or 2 oxygen sensors? i...

hi, i fitted my single mass conversion kit about 2weeks ago which i brought from unipart as was cheap at £150, they said it was a valeo one but it came in there box with no valeo markings on the pressure plate or anything, anyway once fitted it drove fine for about 2 weeks untill this morning...

Hey, i have read and read the forum about double and single mass flywheels and clutch kits and have just got confused! i am getting a hybrid turbo from CR turbo on my PD130 FR ibiza, and need a few questions answering before i purchase the uprated clutch! 1 - do i need to change the...

OK was ringing around today for prices on clutch/flywheel replacement and asked the guy is GSF if they do a SMF for the car. He advised against it saying it will rip the new clutch to shreds as the DMF has a shock absorbing facilty? Once again I am after the advice of the knowledgeable folk? :)

Hi guys , Could you let me know the best place and price to get the air mass sensor from . And should i stay with bosch one . Cheers Joe:think:

im ready to upgrade my clutch and flywheel for a single mass, been pricing them up and found one at unipart which is a valeo one and is 228mm clutch plate, is this correct and has anyone used the ready to go conversion kits from GT, unipart etc. and if so are these good kits or would it be...

Do you always have to change the dual mass flywheel when changing the clutch? Cars done 49,000 miles. Its a lcr.

Hi, Just back from the garage and £1k lighter after a DMF failure. So I thought I'd share my experience and symptoms with the forum. Now the clutch and DMF have been replaced the leon is driving reallt smoothly, I think I've been living with a dodgy flywheel for a long time. I noticed the...

hi there im looking for the fly wheel for my seat 1.9tdi 130bhp. Does anyone know the best place to get one from and prices if anyone has paid for them what they paid, if they like to let me know,.. thanks laot peeps i do appologise if this has been covered be fore.. many thanks

Pretty sure its done it since new. Setting off especially if doing so just on the clutch there's a judder / dull rattle through te transmision. I was advised when I got paranoid when I 1st got it that its the 'noisy dual mass flywheel' Any one else get this? Im expecting the clutch to...

my one is showing a low reading and the guy at amd said replace for a new one.where does everyone shop for there spares cheers

hi everyone i have a quick question if you could help. i have a sachs performance clutch do i need to buy a dual mass as well to go with it, the cluthc only slips when i put my foot down in the low end of the rev range, there is no extra vibrations or any other issues. some peole are saying...

right earlier i broke down and found out to be this sensor so i unplugged it to drive home which was only a couple of miles away neways i got home and plugged it back in to find it running sweet again, my eml light is still on but the car is running fine i dont know what to do. Is it worth me...

What lights will be up on dash, and any other signs? as i think mine has died, its a 210 Amk LCR

Price aside is this everything i need to give a man to replace my clutch? http://www.awesome-gti.co.uk/product.php?xProd=10682&xSec=356 1.9 TDI 110 ASV Engine