measuring

IF I want to confirm if alloys are 4x100 yes 4= no of studs To calculate the 100m spacings between studs I am assuming that you measure from the centre of one hole across the middle of the wheel to the opposite hole centre. I've done this measurement and it reads 100mm exactly. Am I...

My 2.0 tdi (BKD engine) altea is running fine, average fuel consumption, but just isn't pulling as well as a friends standard 2.0 tdi (BKD engine) golf. Which are the appropriate measuring blocks to check for indicators of the cause(s) of poor performance?

I think I know my way round Measuring Blocks for the Mk3 / Mk4 Ibiza and the Leons. However, I haven't had time to get my head round the very basic info that you can get on the Mk2 8v. I don't even know if the 16v is different. Searches haven't really turned up very much. If anyone can help...

Hi, VAG-COM doesnt seam to fine a label file when im on the engine section of measuring blocks. For most other blocks it does fine a label file. Has anybody created a label file for this engine or know a label file which can work for it? Ill post this in the Leon Mk2 specific forum too...

Hi, I have bought a vagcom interface but when I connect the car with laptop PC and run the engine measuring blocks I only have 22 measuring blocks, all others are empty. I have a licence program, and I do not even have 25 blocks as I should have in shareware version. So does my engine...

http://www.seatcupra.net/users/saul/files/VAG_dbw_blocks.doc (word) http://www.seatcupra.net/users/saul/files/VAG_dbw_blocks.xls (excel)

I found a list of what each measuring block contains on the internet (albeit from a guy with a Passat but it looks pretty much the same as my LC), so I've messed around and recompiled it to try to make it easier to find which blocks contain the things you want. If anyone spots any mistakes...

With the new version of Vagcom you can measure 0-60, 0-100 30-70, 1/4 mile, blah blah, How accurate is it? and How does it know how far you are traveling??? Regards Adam

Hello all, I have just spend hours auto scanning through all the modules on my 1.8T Cupra 2003. I have gone through all the measuring blocks and adaptations and have put them into a word document. Question is how do I attach a word document to this message? I cut and paste and it looks rubbish...