servo

rang seat dealers with reg plate no for my 1.8t facelift cupra asking for a replacement servo unit, the part number they gave me was 1J2 614 106 D the part number on my servo fitted is: 1J2 614 105 D question being i can get hold of a new 106D for £85 instead of the seat price of...

should the mk3 ibiza cupra 1.8T master cylinder fit direct onto the mk2 ibiza brake servo? ive looked at part numbers and it suggests that the brake servos are the same part number, and as such the master cylinders should be interchangeable... (I know the pipe fittings are different but ive...

Hi There's a loud hiss coming from behind the dash which stops the harder you press the brake pedal. Took it to my mechanic and he says the brake servo is gubbed. Which makes sense. He's quoted me £450 for parts (£170) and labour. He says the engine block needs shifted to get access to...

I'm looking to replace the 90 degree elbow that comes off of the inlet manifold and onto the brake servo hose which I'm led to believe is 12mm but Forge only list 11 and 13mm elbows? What has everyone else used to replace this? Is it ok to use a 13?

Has anyone tried removing the pedal box and servo replacing them with a balance bar pedal box using separate reservoirs and cylinders for front/rear? This is for my 16v Cupra so G60/16v brake set up which is under 15x7 wheels? I need to know what is the braking effort like, hard or soft...

I have called SEAT UK and they deny that my 01 1.8 20VT Cupra was meant to be recalled. It has split at the opposite end to the brake servo. Is this something I would need specialist equipment or can I just take jubilee clips off and bang on a new one? Cheers

Hi Guys, As i've mentionned on here before, my Brembo's are pretty pants to say the least (cant even get ABS to kick in) and reading numerous threads on here has lead me to believe its most likely a lack of servo assist that is causing the problems. Although the brake servo hose has no...

I have a good normal brake pedal nearly all the time. I'm now finding however that on sustained boost (ie a power run) where it's at 1.4 bar+ for a few seconds, my brake pedal goes hard right at the top. If I brake suddenly, the pedal resists for a fraction of a second before vac cuts in...

ok so I've been to seat and picked up some different parts but can't get them to come together so I'm going to make my own up. Can I do this with samco's? Also do I need to fit one way valves in there along the way or no? If I do then do they have to "arrow" in the direction of the servo...

I know I know another pic request..........:banned: Could someone pop a pic up of theirs and how it routes to the inlet manifold please? I've change over to the right handed manifold and it only has one take off at the end unlike the 180bhp left handed mani which has two - one at the end and...

Anyone know the part number for this?

Hi, my first post here & hoping for some advice. My Ibiza diesel has suddenly acquired HEAVY braking. I thought it was the vacuum pump, and fitted a replacement that I had in the garage, but no good. There's a vacuum at the pump but no servo effect; can anybody point me to a supplier for a...

Just had a quick look through the sticky about the Brake Servo Hose recall and phone my local dealer to check my car out on the system. Looks like it hasnt been done. Where exactly is the Servo Hose so i can have a look at it guys? Thanks.

Hi lal, just to let you know, seat ibiza cupra's with the year 2001 plate, (X , Y and 51) have been recalled, went in to purchase a pipe today and they said its been recalled! :drool: Booked in this week to be replaced free of charge :) **** Dormouse Edit **** Quote RECALL 47S3...