Bilstein B12 Suspension

abristow

Active Member
Jan 4, 2012
68
0
Cyprus
Hi guys hope everyone is ok. Ive recently bought the bilstein b12 for my ibiza 6j cupra. However i hate the ride but something must have gone wrong during installation. Its far too soft in the rear and far to hard in the front. The car isnt balanced and i feel that the front isnt working as it should. Any ideas??
Thanks in advance!
 

Attachments

  • FC4E8DF8-F76A-48F6-988D-1C7A0B7CF1D7.jpeg
    FC4E8DF8-F76A-48F6-988D-1C7A0B7CF1D7.jpeg
    1,013 KB · Views: 64
  • F5C39EDD-5C2C-46AD-B8F1-2CDDC34A8167.jpeg
    F5C39EDD-5C2C-46AD-B8F1-2CDDC34A8167.jpeg
    1.2 MB · Views: 55
  • 0A74CA44-9012-46AC-86F3-87179C552548.jpeg
    0A74CA44-9012-46AC-86F3-87179C552548.jpeg
    995.4 KB · Views: 54
  • 791701E5-6E91-40A6-AB5B-B1C356C40B42.jpeg
    791701E5-6E91-40A6-AB5B-B1C356C40B42.jpeg
    1.1 MB · Views: 56

camelspyyder

2 SEAT-er
Jun 26, 2014
1,305
175
A buddy on Briskoda had the same thing with Eibachs. It turned out the kit fitted was for the heavier diesel model, not the TSI that he drove. The spring rates were too hard at the front, making the ride height wrong and making the car very easy to spin in fast corners ( on track of course). Sounds like you may have the wrong springs.
 

abristow

Active Member
Jan 4, 2012
68
0
Cyprus
Hey ive already checked with the guy who i got them from and he confirmed its for the cupra. The car height is ok. But he did say something like if the suspersion is sitting on the bump stops then it wont work properly so maybe the installation went wrong


Sent from my iPhone using Tapatalk
 
Progressive Parts, performance parts and tuning specialists