Car won't start after rebuild

Jan 6, 2009
1,102
0
sunny falmouth
Iv finally pulled my finger out and finished my cupra (well nearly) its all rebuilt and back in, I went to start it today and all I get is a clonk when I turn the key I also get 3 loud beeps when I turn the ignition on.
I scanned it with a code reader and got these codes
01314
17987
16501
I beleive the top code to be something to do with the engine control module, as far as I'm aware every thing has gone back together correctly
Any one got any ideas ?
Here's a couple of pics of how its looking
5e0b35cb-a826-ccf2.jpg

5e0b35cb-a840-db35.jpg

5e0b35cb-a858-1a40.jpg

5e0b35cb-a876-4469.jpg

Comments welcome to
 
Jul 4, 2007
1,674
0
bristol
To top work mate! Check all your earths sounds like you missed an earth out maybe earth from block to fusebox.
After rebuild I got all kinds of crazy codes so the engine won't turn?
Starter motor all in correct?
Battary got enough juice clunks if you don't have a charged battary
 
Last edited:
Jan 6, 2009
1,102
0
sunny falmouth
Ok so it turns out my crank went in wrong so iv had to have it re-grounded and buy new bearings again o well you learn from your mistakes good news though should be rebuilt soon
Couple of.pics of some painted bits
5e0b35cb-a841-6d11.jpg

5e0b35cb-a85e-db5b.jpg

5e0b35cb-a878-ff8d.jpg
 
Adrian Flux insurance services - discount for forum members.