Hi everyone
Needing to change as it has gone how hard is it to change and do i need any special tool at all
Thank craig
Needing to change as it has gone how hard is it to change and do i need any special tool at all
Thank craig
Hi everyone
Needing to change as it has gone how hard is it to change and do i need any special tool at all
Thank craig
You still have to press the bearing in even if its with the hub, genuine bearings have always been like that. The bearing comes complete with the drive hub, not the bearing housing. That on its own it just under 100 pound.
Has to be pressed in correctly as the ABS rotor is built inside, if its not pressed in far enough it wont work. Also you have to be very carefull of the outer clip on the bearing, it must seat properly into the bearing housing.
Thats the one.
Unless you have a press yeah..lol
Only three? Should be ok
got a 3tonne press at work! the luxuries of industries haha