Separate names with a comma.
Discussion in 'Leon Mk1' started by peterdav, Apr 17, 2012.
can ant one help me with this 1?
AEB: - 1780 150BHp Audi A4/A6, 01 gearbox,
APX: - 1781 225BHP Audi TT, 02 gearbox.
I don't think so.
Depends. What do you want to do?
AEB uses a 058 block which is totally different, easily identifiable as it uses an external water pump.
058 blocks - fitted to early Audi A4's and Passats, around the years 1996-1999.
APX uses a 06A block, cambelt driven internal water pump.
06a blocks - fitted to all traversely mounted engines.
If your thinking of swapping largeport heads around onto 06a blocks then no problem, the only consideration should be the Largeport heads don't have a SAI port. If your going to the process of a head swap then delete the SAI system and run a catch can.
Also the Largeport heads don't have a VVT Camchain tensioner, you can install one though now problems.
hi and thanks for the replys.
i wanted to know if AEB engine will fit and work in my audi tt??
can any one help me out? thanks
can i put 01 leon cupra 1800 20vt engine aqx engine in???
will that work?
i need help
Basically a AEB won't work. It needs to be a 06a block.
Look for AGU, AUQ, AQX, AMK, BAM, etc etc.
As a rule of thumb if the engine comes from a transverse mounted car - Golf mk4, Mk 1 Leon, mk1 Audi TT, Audi S3, then it will physically fit a Audi TT.
There are small differences with the compression ratio's etc with the different engine codes. All the cranks are forged and pistons are forged items (mahle)
The difference are gudgeon pins (wrist pin) size some are 19mm some are 20mm but if your not tuning either would be ok.
The BHP rating of the standard engines i.e 150/180/210/225 isn't set by the engine inside, it's factors like different turbo's intercoolers / mapping etc.
If you not bothered about excessive tuning / and wan't the easiest engine install then i would go with the original engine code, or with a AUQ or similar these 180bhp engines normally fitted with k03s turbos (assuming your replacing a 225bhp version just swap your turbo etc over and bobs your fathers brother
You can pick up AUQ engines for as little as £400 on ebay, if you need one in a hurry then they normally on Buy It Nows around the £5-700 mark.
Hope this help.
will my 180 bhp turbo work aswell? off my leon? on the audi? sorry for all the q,marks lol.
hope s0o cant be that easy.
Only as hard as you make it
Well, you never actually stated what your TT was, so I'm assuming it's a 180 aswell. If its a 225 or a 210 then the turbo is different.
it is 225 bhp so my leon 180 bhp turbo will not fit? am i rite in saying that?
It will fit, but, you have to change alot and it'll run like a bag as its a smaller turbo. You need a K04.
Yeh your right, if your existing setup is a 225bhp car then you will need to keep your existing turbo and inlet manifold.... Basically everything but the engine.
So buy a replacement engine, remove your engine and bolt your existing inlet manifold with injectors complete / turbo inc manifold. Basically everything will fit from your tt engine to the replacement engine.
thanks for reps
so i need a ko4 turbo,. how mutch do thease roughly sell for? new and second hand?if i can get hold of 1, thanks
Circa £300 for a second hand one.
So whats exactly wrong with the car ? is it the engine or turbo ??????
Im going to take a stab at a failed oil pump or blocked pick up which has starved the lot of oil.
both i recon
havnt gone at it yet .so thinking the worst lol