What are the pedals/pedal covers like on your FR trim cars?
The regular normal plastic black covers or aluminum ones?
The regular normal plastic black covers or aluminum ones?
What are the pedals/pedal covers like on your FR trim cars?
The regular normal plastic black covers or aluminum ones?
I drove a Octavia vRS before and currently own a Leon Cupra - the Ibiza is my SWAMBO car and I was surprised when I drove it yesterday for a bit longer that my foot kept sliding of the clutch.
As was mentioned already, should be easy to solve with a quick order from AliExpress
I am full-LEDing her car, since not everything were LEDs.
Reverse light and coding already done (did the same for my Leon) and on the plans rear blinkers, front fogs and interior lights - all already ordered.
Need to order still a brighter LED for the trunk interior and need to convince her to let me change the footwell LEDs for red ones, like I did on my Cupra.
Next up, need to source some good quality trunk liner protection, since the one there is flimsy.
Thanks for the help guys - now I know there is nothing wrong with the pedals
I’d like to do the same to my Ibiza, was the reverse light easy to change? Where did you get all the LED bulbs from mate
You must be careful not hall the led in reverse work it can show a error in the dash, I will tray to show a picture of the ones that work in my Ibiza with no error.
I am busy here so cannot give a detailed reply - the LEDs I got all from AliExpress.
The reverse bulb was simply removing the rear light - not so easy to pry it open after removed, but I did it.
When I do the LED blinkers I might make a guide video.
The coding was not documented anywhere, so I had to figure which one was the correct bulb to recode - all channels are slightly different on this Ibiza...
Changing to led the blinkers do you need a resistance to avoid the fast blinker?
Hi I followed all the steps jaco2k to put a led in the reverse light, but in the end it asks for a 5-digit login, does anyone know what that means?Of course not - once again, the right way to do it is NOT to use resistors or supposedly canbus friendly LEDs but instead just recode it on the car.
For instance, for the reverse light, this is the channel and change in OBDeleven:
It shows a lot of
numbers. Do I pik one?