(PICTURE UPDATES) my red ko3s cupra

[kelvin_redcupra]

hi all just thought i wud show you all a few pics of my car i got it in october 2009 completely standard,i am planning to do a k04 turbo conversion

mods so far
scorpion cat back
k&n induction kit
uni FMIC (fitted this weekend)
n112 valve removed
n249 valve bypassed
replaced all vac hose with red & blue silicone
resprayed rocker cover in white
fitted lcr font splitter
debadged & de wipered

Future mods
KO4 turbo (already purchased)
all bits to do k04 conversion
g60 flywheel & vr6 clutch
set of FK coilovers
20mm rear spacers
Brake upgraded (not decided yet tho lol)
forge 007 dv
then finally get it all mapped with all bits fitted

Got a bit bored over christmas so thought i'd tidy up the bay abit.

Going to do the inlet in sapphire cossie grey next

Ive been busy fitting my Fmic this weekend what a pig of a job that turned out to be as the uni intercooler doesnt fit behind the bumper properly so i had to do sum bumper modifications i will get some pics of it fitted mid week as i am just waiting for bumper to dry as i had to re-spray it and my uprated intercooler pipe clamps wont turn up till tuesday cnt wait lol

comments welcome gud and bad also any ideas on what mods nxt wud be appreciated lol​

 

[GtSport]

Nice Job, man! Good Luck with your future mods! After the k04 conversion your Ibiza will be a rocket.

 

[kelvin_redcupra]

yeah i hope so m8

 

[wizzie24]

lovely car mate, i like the front bumper i was thinkin about doing the same when i finaly buy a fmic keep up the good work cant wait to c the finnished product

 

[Hansbury]

nice engine bay mate where abouts in staffs are you from?

 

[rich_cupra]

Hello mate like the way u done the front bumper. Wot set up u going to run with the ko4? Wot power are the good for?

 

[kelvin_redcupra]

as close to 300 bhp as poss i hope m8

 

[kelvin_redcupra]

nice engine bay mate where abouts in staffs are you from?

live in leek m8

 

[kelvin_redcupra]

my red ibiza k03s

Just thought i wuould update my thread as money has been a bit tight lately an not been able to do much on the k04 front so i now changed my plans an goin for a ko3s setup for a while till the cash flow is better

few pics of my intercooler and bumper fitted:

also been busy with the paint over the last few weeks makin a mess of me nans shed
had a go at me frt and rear badges in ford graphite grey:

after the badges turned out ok thought i would av a go at a wheel

wernt to struck on the colour for the wheels so i sent the off to be powder coated in anthracite an got 4 new toyo proxie t1rs fitted at the same time al post pics at the weekend.

decided to have a go at painting me inlet this week aswell thought i wud try sumet a bit diffrent

not sure bwt the colour ??

my next step is to get a stage 2 map just got a k03s and going to order a blueflame decat pipe an g60 flywheel an vr6 clutch. hopefully fitting turbo at the weekend
let me no what you think

 

[kelvin_redcupra]

my ko3 s cupra (Picture Updates)

just fitted my ko3s at the weekend

here is both the turbos not much different to ko3 but can tell the difference when driving it

just a few pics of my wheels refurbed in anthracite on the car

also had a change of coulor on my rocker cover as the white was too hard to keep clean

had to have me car off the road for a few days until my forge ko3s turbo pipe turned up as i used the standard one and after 3days it decided to blow off lol
goin to fit my blueflame decat at the weekend and a 4bar fpr then goin to gets my map swapped to stasge 2