Separate names with a comma.
Discussion in 'Mk4 Ibiza Guides (6L) 2002-2008' started by st10587, Jul 11, 2009.
Brilliant, I have this to do tonight, saves me losing my temper LOL
Hi, what screwdriver do i need to do this?
from memory a T25 torx driver and a flat blade to get the lights out
Thanks, will have a go tomorrow
How relevent is this to the Cordoba with it's bigger bum?
Got a slight dent in the plastic trim round the bottom that I want to access and try to pop out.
Or I might just get a hair dryer on it and save me the trouble of removing the whole bumper!
I have removed the bumper a lot of times, but I never did not notice a thing, I hope you can answer me ;-)
It's possible to install a little tube for the exhaust from sx to sx? I want a dx sx exhaust, i think to weld another round final on dx, but I do not want fake exhaust on dx.
I think that a tube with 2 cm of diameter can enter behind the part of grey plastic.
Do you think it enter?
Is there anything very different to do on a Cordoba?
It looks very similar but not entirely sure.
Awesome! Searched looking to find how to take my Cupra bumpers off and found this thread created for me putting them on
Perfect , thanks for the info.
..........just about to hava go at changing my Seat Ibiza rear bumper,
thanx for this guide!
I also need to do this to replace my broken near side reflector (see pic)
Does anyone know if these just clip in / out behind the bumper and is it necessary to remove the whole bumper to do this?