Separate names with a comma.
Discussion in 'Leon Mk2' started by ferooo, May 6, 2012.
Depends on what sort of display you have here is the link you need to have one with the angle sensor capability and your new module will need coding with vcds
I have the large MFD with Bluetooth if that's what you mean? Is the CH controller the correct one? I already have my steering wheel just need the airbag and controller now, does anyone have instructions on how to code? I have access to vag-com
I have the large mfd too with cruise control But no Bluetooth. I bought the cd model first but that wasn't compatible with the angle sensor so steering wheel light was on constantly then changed to ch model and it was fine they are hard to come by though. I bought mine from eBay.
Coding somebody did this for me but I think it's fairly straight forward if you go in to the steering wheel module I think the coding for mine was 005349. When you go in to that module on vcds it gives you guidelines as to what your code needs to be
I've been told you need two modules? Also I have the normal dash with no display
Can I ask why you wanted the pre FL wheel on your FL car?
Chap who made the thread put it the wrong way round
any more ideas on this???? really want to do it but dont know what i need to do
that steering wheel is pre-FL
Hmmmm has anyone done this?
I know this is a few years since the last post.
I have recently completed this mod, all you need is the correct steering wheel controller. I got the ch model as before i had changed the steering wheel i changed the cluster to the large red screen fr version so it was compatible.
Then you just need the steering wheel itself plus the correct airbag. I got the 09 fl leon fr flat bottom wheel. I then noticed the same airbag is used in the 09 onwards alteas and toledo so i got that.
Once you have the 3 items plus vcds its just a case of removing the old controller and wheel, search you tube if you are unsure of how to do this. Install new steering wheel, make sure the dot on both the steering column and steering wheel allign correctly. Tighten the bolt to 30nm as per elsawin.
Connect the wires between the airbag and steering wheel for the horn and steering wheel controls then connect the main yellow plug to the slip ring, push the airbag all the way in until it clicks in place if it doesnt the wires are in the way.
Connect battery then open vcds go to steering wheel controller and code it in as per your vehicle. Then the install is complete just remember to do steering assist basic setting so the yellow light on the dash goes off and the steering is not heavy. See rosstech for this procedure.
Hope this helps someone wanting to do this mod