Dismiss Notice
Hi Guest, stickers are available from our online store.

toledo limp mode issue

Discussion in 'MK1 & MK2 Toledo' started by malc@heeley3171, Mar 19, 2010.

  1. Hi , my 2002 Toledo 1.9TDI is going into limp mode again after having the MAP and the other devices, vacuums etc replaced about 18 months ago. diagnostics incdicate pressure control problem. I intend to change the 5mm vacuum pipes could there be anything else causing me this grief. Thankyou. Malc
     
  2. silver surfer

    silver surfer Full Member

    Joined:
    Mar 31, 2006
    Messages:
    470
    Likes Received:
    1
    pressure problem

    try removing connection to boost pressure switch in top of intercooler behind offside headlight
    check wiring and if connections are clean then refit and try as one on my car it falted and i removed and refitted and has been ok since
     
  3. thanks silver surfer. The cause of the problem finally came to light when I put my foot down. A sudden small bang and loss of pressure - the intercooler pipe had slipped over onto the pulley. New pipe (S/H) now fitted and car runs spot on.
     
  4. silver surfer

    silver surfer Full Member

    Joined:
    Mar 31, 2006
    Messages:
    470
    Likes Received:
    1
    boost problem

    good to here you got it sorted
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice