Finally getting around to updating my forge intake. as the wire im using to hold it up keeps breaking meaning the pipe falls halfway down, not good for my lil engine 
so it looks like this atm with a cut up bit of forge tubing at the grille. Problem is the Grill is like this:
[ ] and the tubing is like O so im missing out on air [ O ]
Going to pick one of these up it should *just fit* the next size down is half the width and has a smaller connecting pipe so wont fit over the pipework i currently have.
so it looks like this atm with a cut up bit of forge tubing at the grille. Problem is the Grill is like this:
[ ] and the tubing is like O so im missing out on air [ O ]
Going to pick one of these up it should *just fit* the next size down is half the width and has a smaller connecting pipe so wont fit over the pipework i currently have.
