What work is in involved? is it plug and play or do i need to get looms out of a toledo and plumb them in to my non electric LEON?
Wiring in Electric Toledo leathers
- Thread starter Claki
- Start date
To get them working, you just need a power feed (+12v and GND) to go to the seats. They're not exactly 'plug and play' and the Toledo loom won't really help (apart from providing you with a length of wire and a connector). But it's not a difficult job.
Do a search on here, there should be a fair few threads showing which two wires need the power and some suggestions on where to get it from.
Do a search on here, there should be a fair few threads showing which two wires need the power and some suggestions on where to get it from.
http://www.seatcupra.net/forums/showthread.php?t=330329
Thats the one i used mate, was spot on. You might need to wire the old seat airbag plugs into the new seats and if you do disconnect the battery and don't reconnect until after they are both done, or you get a light like i did.
Also you might need some different bolts to secure the driver and passenger seats because mine were different fitment.
Thats the one i used mate, was spot on. You might need to wire the old seat airbag plugs into the new seats and if you do disconnect the battery and don't reconnect until after they are both done, or you get a light like i did.
Also you might need some different bolts to secure the driver and passenger seats because mine were different fitment.
Similar threads
