Have a 2002 Toledo 1.9SE.
Have just replaced the antiroll bar bushes and link arm bushes with polybushes, and what a difference, much tighter and feels great.
Went to replace the front wishbone bushes but hit a snag, cannot remove the wishbone. Have read on a forum that after removing bolts the lower ball joint should slide out of the wishbone end. Tried this but the driveshaft does not appear to have enough movement. Is this me not being forceful or do you need to release the driveshaft from the gearbox. Have searched several forums but have found no clear instructions.
Also replaced the dogbone bushes, with lots of initial vibration, will have to see what happens over next week.
Have just replaced the antiroll bar bushes and link arm bushes with polybushes, and what a difference, much tighter and feels great.
Went to replace the front wishbone bushes but hit a snag, cannot remove the wishbone. Have read on a forum that after removing bolts the lower ball joint should slide out of the wishbone end. Tried this but the driveshaft does not appear to have enough movement. Is this me not being forceful or do you need to release the driveshaft from the gearbox. Have searched several forums but have found no clear instructions.
Also replaced the dogbone bushes, with lots of initial vibration, will have to see what happens over next week.